- 1,2-Hexadecylene oxide
- Vikolox 16
White waxy solid or clear colorless liquid. Faint pleasant odor.
Chemical intermediate for surface-active agents, fabric softeners, cosmetic ingredients, textile finishes, & synthetic waxes.
Registry Numbers and Inventories.
Japan ENCS (MITI)
Melting point, °C
21 - 22
Boiling point, °C
Vapor pressure, mmHg
0.0005 (25 C)
0.8457 g/cm3 (20 C)
Solubility in water
1.4445 (20 C)
Partition coefficient, pKow
Heat of vaporization
Hazards and Protection.
Keep in a cool, dry, dark location in a tightly sealed container or cylinder. Keep away from incompatible materials, ignition sources and untrained individuals. Secure and label area. Protect containers/cylinders from physical damage.
All chemicals should be considered hazardous. Avoid direct physical contact. Use appropriate, approved safety equipment. Untrained individuals should not handle this chemical or its container. Handling should occur in a chemical fume hood.
Chemical splash goggles in compliance with OSHA regulations are advised; however, OSHA regulations also permit other type safety glasses. Whre chemical resistant gloves. To prevent repeated or prolonged skin contact, wear impervious clothing and boots.
Wear a NIOSH-approved half face respirator equipped with an organic vapor/acid gas cartridge (specific for organic vapors, HCl, acid gas and SO2) with a dust/mist filter.
If a spill of this chemical occurs, FIRST REMOVE ALL SOURCES OF IGNITION, then you should dampen the solid spill material with acetone and transfer the dampened material to a suitable container. Use absorbent paper dampened with acetone to pick up any remaining material. Seal your contaminated clothing and the absorbent paper in a vapor-tight plastic bag for eventual disposal. Solvent wash all contaminated surfaces with acetone followed by washing with a soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned.
Sensitive to prolonged exposure to heat Reacts with inorganic acids, thiosulfate, carboxylic acids, hydrogen cyanide, water, amines, aldehydes, alcohols, and caustics
Fires involving this compound should be controlled using a dry chemical, carbon dioxide or Halon extinguisher.
This material is probably combustible.
Exposure to this compound may result in skin irritation which is characterized by localized lesions, redness, swelling and itching. Chronic symptoms include loss of body weight, gastric irritation and moderate liver damage. Prolonged inhalation may cause acute pulmonary edema or chemical pneumonia. It also causes sensitization.
DO NOT INDUCE VOMITING. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. Be prepared to transport the victim to a hospital if advised by a physician.
IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used.
IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. If symptoms such as redness or irritation develop, IMMEDIATELY call a physician and be prepared to transport the victim to a hospital for treatment.
First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop.