2-Dimethylaminoethyl acrylate

  • 2-(Diethylamino)ethyl acrylate
Formula
C7H13NO2
Structure
Description
A colorless to light yellow liquid with an acrid odor.

Registry Numbers and Inventories.
CAS
2439-35-2
EC (EINECS/ELINCS)
219-460-0
R 21/22 26 34
S 26 28 36/37/39 45
RTECS
AS8578000
RTECS class
Mutagen
UN (DOT)
3302
Beilstein/Gmelin
1099119
Beilstein Reference
4-04-00-01431
Canada DSL/NDSL
NDSL
US TSCA
Listed
Austrailia AICS
Listed
New Zealand
Listed
Japan ENCS (MITI)
Listed
Korea ECL
Listed

Properties.
Formula
C7H13NO2
Formula mass
143.21
Melting point, °C
<-60
Boiling point, °C
177
Vapor pressure, mmHg
1 (25 C)
Density
0.9406 g/cm3 (20 C)
Solubility in water
Very soluble
Refractive index
1.4372 (20 C)
pKa/pKb
5.79 (pKb)
Partition coefficient, pKow
0.95
Heat of vaporization
41.4 kJ/mol

Hazards and Protection.
Storage
Keep in a cool, dry, dark location in a tightly sealed container or cylinder. Keep away from incompatible materials, ignition sources and untrained individuals. Secure and label area. Protect containers/cylinders from physical damage.
Handling
All chemicals should be considered hazardous. Avoid direct physical contact. Use appropriate, approved safety equipment. Untrained individuals should not handle this chemical or its container. Handling should occur in a chemical fume hood.
Protection
If Tyvek-type disposable protective clothing is not worn during handling of this chemical, wear disposable Tyvek-type sleeves taped to your gloves.
Respirators
When working with this chemical, wear a NIOSH-approved full face chemical cartridge respirator equipped with the appropriate organic vapor cartridges. If that is not available, a half face respirator similarly equipped plus airtight goggles can be substituted. However, please note that half face respirators provide a substantially lower level of protection than do full face respirators.
Small spills/leaks
Keep material out of water sources and sewers. Use water spray to knock-down vapors. Land spill: Dig a pit, pond, lagoon, holding area to contain liquid or solid material. Dike surface flow using soil, sand bags, foamed polyurethane, or foamed concrete. Absorb bulk liquid with fly ash, cement powder, or commercial sorbents. Water spill: Use natural barriers or oil spill control booms to limit spill travel. Remove trapped material with suction hoses.
Stability
No data.
Incompatibilities
Incompatible with isocyanates, halogenated organics, peroxides, phenols (acidic), epoxides, anhydrides, and acid halides Flammable gaseous hydrogen is generated in combination with strong reducing agents, such as hydrides Strong oxidizing acids may cause a vigorous reaction that is sufficiently exothermic to ignite the reaction products.

Fire.
Flash Point,°C
58
Fire fighting
Use water in flooding quantities as fog. Use foam, dry chemical, or carbon dioxide. Cool all affected containers with flooding quantities of water. Apply water from as far a distance as possible. Keep run-off water out of sewers and water sources.
Fire potential
This chemical is flammable.
Hazards
Containers may explode when heated. Runoff may pollute waterways. Substance may be transported in a molten form.
Combustion products
Fire may produce irritating, corrosive and/or toxic gases.

Health.
Exposure effects
The toxological properties of this substance have not been fully investigated.
   Inhalation
Highly toxic, may be fatal if inhaled, swallowed or absorbed through skin. Effects of contact or inhalation may be delayed.
   Skin
Contact with molten substance may cause severe burns to skin and eyes. Avoid any skin contact.
   Eyes
See Skin.

First aid
 
   Ingestion
DO NOT INDUCE VOMITING. Corrosive chemicals will destroy the membranes of the mouth, throat, and esophagus and, in addition, have a high risk of being aspirated into the victim's lungs during vomiting which increases the medical problems. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. IMMEDIATELY transport the victim to a hospital. If the victim is convulsing or unconscious, do not give anything by mouth, ensure that the victim's airway is open and lay the victim on his/her side with the head lower than the body. DO NOT INDUCE VOMITING. Transport the victim IMMEDIATELY to a hospital.
   Inhalation
IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used.
   Skin
IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. IMMEDIATELY call a hospital or poison control center even if no symptoms (such as redness or irritation) develop. IMMEDIATELY transport the victim to a hospital for treatment after washing the affected areas.
   Eyes
First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop.

Transport.
UN number
3302
Response guide
Hazard class
6.1
Packing Group
II
 
Std. Transport #
4923119