Dibromobenzene

Formula
C6H4Br2
Structure
Description
A dense liquid with a pleasant aromatic odor.

Registry Numbers and Inventories.
CAS
26249-12-7
EC (EINECS/ELINCS)
247-544-7
RTECS
CZ1780000
RTECS class
Other
UN (DOT)
2711
Beilstein/Gmelin
NA
Canada DSL/NDSL
NDSL
US TSCA
Listed

Properties.
Formula
C6H4Br2
Formula mass
235.92
Melting point, °C
42
Boiling point, °C
216
Critical temperature
467
Critical pressure
55.0
Partition coefficient, pKow
3.69

Hazards and Protection.
Storage
Keep in a cool, dry, dark location in a tightly sealed container or cylinder. Keep away from incompatible materials, ignition sources and untrained individuals. Secure and label area. Protect containers/cylinders from physical damage.
Handling
All chemicals should be considered hazardous. Avoid direct physical contact. Use appropriate, approved safety equipment. Untrained individuals should not handle this chemical or its container. Handling should occur in a chemical fume hood.
Protection
Chemical splash goggles in compliance with OSHA regulations are advised; however, OSHA regulations also permit other type safety glasses. Whre chemical resistant gloves. To prevent repeated or prolonged skin contact, wear impervious clothing and boots.
Respirators
Use NIOSH/MSHA approved respirator appropriate for exposure of concern.
Small spills/leaks
Keep sparks, flames, and other sources of ignition away. Keep material out of water sources and sewers. Build dikes to contain flow as necessary. Attempt to stop leak if without undue personnel hazard.
Stability
No data.
Incompatibilities
Incompatible with strong oxidizing and reducing agents Incompatible with many amines, nitrides, azo/diazo compounds, alkali metals, and epoxides.

Fire.
Flash Point,°C
47.2
Fire fighting
Use water in flooding quantities as fog. Use alcohol foam, dry chemical or carbon dioxide. Cool all affected containers with flooding quantities of water. Apply water from as far a distance as possible. Keep run-off water out of sewers and water sources.
Fire potential
HIGHLY FLAMMABLE.
Hazards
Vapors may form explosive mixtures with air. Vapors may travel to source of ignition and flash back. Most vapors are heavier than air. They will spread along ground and collect in low or confined areas (sewers, basements, tanks). Vapor explosion hazard indoors, outdoors or in sewers. May polymerize explosively when heated or involved in a fire. Runoff to sewer may create fire or explosion hazard. Containers may explode when heated. Many liquids are lighter than water.

Health.
Exposure effects
   Ingestion
See inhalation.
   Inhalation
May cause toxic effects if inhaled or absorbed through skin. Inhalation or contact with material may irritate or burn skin and eyes. Fire will produce irritating, corrosive and/or toxic gases. Vapors may cause dizziness or suffocation. Runoff from fire control or dilution water may cause pollution.
   Skin
See inhalation.
   Eyes
See inhalation

First aid
 
   Ingestion
Seek medical attention. If individual is drowsy or unconscious, do not give anything by mouth; place individual on the left side with the head down. Contact a physician, medical facility, or poison control center for advice about whether to induce vomiting. If possible, do not leave individual unattended.
   Inhalation
If symptoms develop, move individual away from exposure and into fresh air. If symptoms persist, seek medical attention. If breathing is difficult, administer oxygen. Keep person warm and quiet; seek immediate medical attention.
   Skin
Remove contaminated clothing. Wash exposed area with soap and water. If symptoms persist, seek medical attention. Launder clothing before reuse.
   Eyes
If symptoms develop, immediately move individual away from exposure and into fresh air. Flush eyes gently with water for at least 15 minutes while holding eyelids apart; seek immediate medical attention.

Transport.
UN number
2711
Response guide
36. Halogenated hydrocarbons
Std. Transport #
4909299