Diiron monophosphide

  • Di-iron phosphide
  • Ferrous phosphide
  • Iron phosphide
Formula
Fe2P
Structure
Description
Gray, hexagonal needles or blue-gray powder.
Uses
Iron & steel manufacture.

Registry Numbers and Inventories.
CAS
1310-43-6
EC (EINECS/ELINCS)
215-178-7
Merck
12,4102
Beilstein/Gmelin
9253 (G)
Canada DSL/NDSL
DSL
US TSCA
Listed
Austrailia AICS
Listed
Japan ENCS (MITI)
Listed
Korea ECL
Listed

Properties.
Formula
Fe2P
Formula mass
142.66
Melting point, °C
1420
Density
6.85 g/cm3 (20 C)
Solubility in water
insoluble

Hazards and Protection.
Storage
Keep in a cool, dry, dark location in a tightly sealed container or cylinder. Keep away from incompatible materials, ignition sources and untrained individuals. Secure and label area. Protect containers/cylinders from physical damage.
Handling
All chemicals should be considered hazardous. Avoid direct physical contact. Use appropriate, approved safety equipment. Untrained individuals should not handle this chemical or its container. Handling should occur in a chemical fume hood.
Protection
Chemical splash goggles in compliance with OSHA regulations are advised; however, OSHA regulations also permit other type safety glasses. Whre chemical resistant gloves. To prevent repeated or prolonged skin contact, wear impervious clothing and boots.
Respirators
Use NIOSH/MSHA approved respirator appropriate for exposure of concern.
Small spills/leaks
Evacuate area and ventilate. Wear protective equipment. If required, use an inert absrobent. Sweep up and place in an appropriate container for disposal. Wash contaminated surfaces.
Stability
No data.
Incompatibilities
Strong oxidizing agents.

Fire.
Fire fighting
Wear a self-contained breathing apparatus in pressure-demand, MSHA/NIOSH (approved or equivalent), and full protective gear. During a fire, irritating and highly toxic gases may be generated by thermal decomposition or combustion. Use agent most appropriate to extinguish fire.
Fire potential
Evolves. Flammable products on exposure to moisture or acids.

Health.
Exposure effects
Blood pressure may be decreased following an iron overdose. Lethargy, restlessness or confusion may be seen early in the poisoning. Convulsions and coma may occur in later phases. Case reports of pregnant women who have received early aggressive treatment (decontamination and/or deferoxamine) have described good fetal outcomes.
   Ingestion
Nausea, vomiting, diarrhea and gastrointestinal hemorrhage may develop.
   Inhalation
Noncardiogenic pulmonary edema may develop with severe intoxication.
   Skin
Severe thermal burn with ferrous sulfate slurry has caused classical symptoms of ingested iron poisoning.

First aid
 
   Ingestion
The possible benefit of early removal of some ingested material by cautious gastric lavage must be weighed against potential complications of bleeding or perforation. Activated charcoal activated charcoal binds most toxic agents and can decrease their systemic absorption if administered soon after ingestion. Activated charcoal: administer charcoal as a slurry (240 ml water/30 g charcoal). Usual dose: 25 to 100 g in adults/adolescents.
   Inhalation
If symptoms develop, move individual away from exposure and into fresh air. If symptoms persist, seek medical attention. If breathing is difficult, administer oxygen. Keep person warm and quiet; seek immediate medical attention.
   Skin
Remove contaminated clothing. Wash exposed area with soap and water. If symptoms persist, seek medical attention. Launder clothing before reuse.
   Eyes
If symptoms develop, immediately move individual away from exposure and into fresh air. Flush eyes gently with water for at least 15 minutes while holding eyelids apart; seek immediate medical attention.

Transport.