- Ethyl phenyl dichlorosilane
- Silane, dichloroethylphenyl
Colorless liquid. Sharp odor like hydrochloric acid.
Registry Numbers and Inventories.
Japan ENCS (MITI)
Boiling point, °C
Vapor pressure, mmHg
0.13 (25 C)
Vapor density (air=1)
1.1564 g/cm3 (20 C)
Solubility in water
1.5182 (20 C)
Partition coefficient, pKow
Heat of vaporization
Heat of combustion
Hazards and Protection.
Keep in a cool, dry, dark location in a tightly sealed container or cylinder. Keep away from incompatible materials, ignition sources and untrained individuals. Secure and label area. Protect containers/cylinders from physical damage.
All chemicals should be considered hazardous. Avoid direct physical contact. Use appropriate, approved safety equipment. Untrained individuals should not handle this chemical or its container. Handling should occur in a chemical fume hood.
Wear appropriate protective gloves, clothing and goggles.
Wear positive pressure self-contained breathing apparatus (SCBA).
Keep sparks, flames, and other sources of ignition away. Keep material out of water sources and sewers. Build dikes to contain flow as necessary. Use water spray to knock-down vapors. Do not use water on material itself. Neutralize spilled material with crushed limestone, soda ash, or lime.
Use dry chemical, dry sand, or carbon dioxide. Do not use water on material itself. If large quantities of combustibles are involved, use water in flooding quantities as spray and fog. Use water spray to knock-down vapors. Cool all affected containers with flooding quantities of water. Apply water from as far a distance as possible.
Combustible material: may burn but does not ignite readily.
Substance will react with water (some violently) releasing flammable, toxic or corrosive gases and runoff. When heated, vapors may form explosive mixtures with air: indoors, outdoors, and sewers explosion hazards. Most vapors are heavier than air. They will spread along ground and collect in low or confined areas (sewers, basements, tanks). Vapors may travel to source of ignition and flash back. Contact with metals may evolve flammable hydrogen gas.
Toxic hydrogen chloride and phosgene fumes may be formed.
Gastrointestinal tissue corrosion was observed in animals given single oral doses and may occur in humans following ingestion.
Three cases of permanently disabling reactive airway syndrome have been reported in adults exposed for several hours to fumes of sodium hydroxide, trichlorosilane, and silicon tetrachloride.
The application of chlorosilanes to shaved rabbit skin produced various degrees of irritation. Complete denaturation and tissue sloughing occurred within one minute after exposure to dichlorodimethylsilane, within two to three minutes after exposure to methyltrichlorosilane, ethyltrichlorosilane, and dichlorodiethylsilane, and within 10 minutes after exposure to tetrachlorosilane.
Dilution: immediately dilute with 4 to 8 ounces (120 to 240 ml) of milk or water (not to exceed 4 ounces/120 ml in a child). Do not induce vomiting.
Remove victim to fresh air; give artificial respiration if needed; call physician.
Flush with water; obtain medical attention if burning has occurred.
Irrigate exposed eyes with copious amounts of tepid water for at least 15 minutes. If irritation, pain, swelling, lacrimation, or photophobia persist, the patient should be seen in a health care facility.
USCG CHRIS Code
Std. Transport #