Registry Numbers and Inventories.
Melting point, °C
Boiling point, °C
0.825 (25 C)
Solubility in water
1.4470 (25 C)
Partition coefficient, pKow
Hazards and Protection.
Keep in a cool, dry, dark location in a tightly sealed container or cylinder. Keep away from incompatible materials, ignition sources and untrained individuals. Secure and label area. Protect containers/cylinders from physical damage.
All chemicals should be considered hazardous. Avoid direct physical contact. Use appropriate, approved safety equipment. Untrained individuals should not handle this chemical or its container. Handling should occur in a chemical fume hood.
Wear appropriate protective gloves, clothing and goggles.
Wear positive pressure self-contained breathing apparatus (SCBA).
(Non-Specific -- Alkylamine, n.o.s. (Corrosive)) Do not touch spilled material; stop leak if you can do so without risk. Small spills: absorb with sand or other noncombustible absorbent material and place into containers for later disposal. Small dry spills: with clean shovel place material into clean, dry container and cover; move containers from spill area. Large spills: dike far ahead of spill for later disposal. Keep unnecessary people away; isolate hazard area and deny entry. Stay upwind; keep out of low areas.
Incompatible with isocyanates, halogenated organics, peroxides, phenols (acidic), epoxides, anhydrides, and acid halides.
(Non-Specific -- Alkylamine, n.o.s. (Corrosive)) Keep unnecessary people away; isolate hazard area and deny entry. Stay upwind; keep out of low areas. Wear self-contained (positive pressure if available) breathing apparatus and full-protective clothing.(Non-Specific -- Alkylamine, n.o.s. (Corrosive)) This material may react violently with water. Small fires: dry chemical, carbon dioxide, water spray, or foam. Large fires: water spray, fog, or foam. Move container from fire area if you can do so without risk. Spray cooling water on containers that are exposed to flames until well after fire is out.
Non-combustible, substance itself does not burn but may decompose upon heating to produce corrosive and/or toxic fumes.
Contact with metals may evolve flammable hydrogen gas.
Fire may produce irritating, corrosive and/or toxic gases.
Circulatory collapse may develop. No data were available to assess the teratogenic potential of this agent. <br>No data were available to assess the potential effects of exposure to this agent during pregnancy or lactation. <br>No information about possible male reproductive effects was found in available references.
Drooling, gagging, vomiting, and chest or upper abdominal pain may occur following ingestion.
Respiratory tract irritation may be seen. Pulmonary congestion and edema may occur.
Dbhmd is very corrosive to the skin.
Eye and upper respiratory tract irritation may occur. Corneal burns are possible. Ingestion could cause burns and edema of the throat; edema of the glottis with possible airway compromise could result.
Do not induce vomiting - following ingestion and/or prior to gastric evacuation, immediately dilute with 4 to 8 ounces (120 to 240 ml) of milk or water (not to exceed 15 ml/kg in a child).
Move patient to fresh air. Monitor for respiratory distress. If cough or difficulty breathing develops, evaluate for respiratory tract irritation, bronchitis, or pneumonitis. Administer oxygen and assist ventilation as required. Treat bronchospasm with beta2 agonist and corticosteroid aerosols.
Remove contaminated clothing, wash exposed area with copious amounts of water. A physician should examine the area if irritation or pain persists. Chemical burns - treatment of chemical burns may be required. Refer to treatment/dermal exposure section in the main body of this document for more information. Treat dermal irritation or burns with standard topical therapy. Patients developing dermal hypersensitivity reactions may require treatment with systemic or topical corticosteroids or antihistamines.
Irrigate exposed eyes with copious amounts of tepid water for at least 15 minutes. If irritation, pain, swelling, lacrimation, or photophobia persist, the patient should be seen in a health care facility. Because of the potential for severe eye injury following direct exposure, prolonged initial flushing and early ophthalmologic consultation are advisable.
I; II; III
USCG CHRIS Code