N,N-Diethyl-4-nitrobenzenamine

  • p-Nitro-N,N-diethylaniline
  • N,N-Diethyl-4-nitroaniline
  • Benzenamine, N,N-diethyl-4-nitro
Formula
C10H14N2O2
Structure
Description
Yellow needles (from ligroin) or yellow crystalline mass.

Registry Numbers and Inventories.
CAS
2216-15-1
EC (EINECS/ELINCS)
218-685-1
UN (DOT)
1661
Beilstein/Gmelin
2213379
Beilstein Reference
3-12-00-01618
Canada DSL/NDSL
NDSL
US TSCA
Listed

Properties.
Formula
C10H14N2O2
Formula mass
194.23
Melting point, °C
77
Density
1.225 g/cm3 (20 C)
Solubility in water
<0.1 g/100 mL at 20 C
Partition coefficient, pKow
2.84

Hazards and Protection.
Storage
Keep in a cool, dry, dark location in a tightly sealed container or cylinder. Keep away from incompatible materials, ignition sources and untrained individuals. Secure and label area. Protect containers/cylinders from physical damage.
Handling
All chemicals should be considered hazardous. Avoid direct physical contact. Use appropriate, approved safety equipment. Untrained individuals should not handle this chemical or its container. Handling should occur in a chemical fume hood.
Protection
Wear appropriate protective gloves, clothing and goggles.
Respirators
Where the neat test chemical is stored, weighed and diluted, wear an approved half face respirator equipped with an organic vapor/acid gas cartridge (specific for organic vapors, HCl, acid gas and SO2) with a dust/mist filter.
Small spills/leaks
Should a spill occur while you are handling this chemical, FIRST REMOVE ALL SOURCES OF IGNITION, then you should dampen the solid spill material with 60-70% ethanol and transfer the dampened material to a suitable container. Use absorbent paper dampened with 60-70% ethanol to pick up any remaining material. Seal the absorbent paper, and any of your clothes, which may be contaminated, in a vapor-tight plastic bag for eventual disposal. Solvent wash all contaminated surfaces with 60-70% ethanol followed by washing with a soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned.
Stability
No data.
Incompatibilities
Incompatible with isocyanates, halogenated organics, peroxides, phenols (acidic), epoxides, anhydrides, and acid halides Flammable gaseous hydrogen is generated in combination with strong reducing agents, such as hydrides If mixed with reducing agents, including hydrides, sulfides and nitrides, they may begin a vigorous reaction that culminates in a detonation.

Fire.
Fire fighting
Fires involving this material can be controlled with a dry chemical, carbon dioxide or Halon extinguisher.
Fire potential
This material is probably combustible.
Hazards
When heated, vapors may form explosive mixtures with air: indoors, outdoors, and sewers explosion hazards.
Combustion products
Fire may produce irritating, corrosive and/or toxic gases.

Health.
Exposure effects
   Ingestion
See Inhalation.
   Inhalation
TOXIC; inhalation, ingestion, or skin contact with material may cause severe injury or death. Effects of contact or inhalation may be delayed.
   Skin
Contact with molten substance may cause severe burns to skin and eyes. See Inhalation.
   Eyes
See Inhalation.

First aid
 
   Ingestion
If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. Be prepared to transport the victim to a hospital if advised by a physician.
   Inhalation
IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used.
   Skin
IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. If symptoms such as redness or irritation develop, IMMEDIATELY call a physician and be prepared to transport the victim to a hospital for treatment.
   Eyes
First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop.

Transport.
UN number
1661
Response guide
Hazard class
6.1
Packing Group
II