Santocure

  • N,N'-Bis-(1,4-dimethyl-pentyl)-p-phenylenediamine
  • N-t-Butyl-2-benzothiazole-sulfenimide
Formula
C20H36N2
Structure
Description
Deep red slightly viscous liquid with an aromatic odor.
Uses
Accelerator used in the production of rubber type polymers.

Registry Numbers and Inventories.
CAS
3081-14-9
EC (EINECS/ELINCS)
221-375-9
RTECS
SS8400000
RTECS class
Other
UN (DOT)
1673
Beilstein/Gmelin
2739028
Canada DSL/NDSL
DSL
US TSCA
Listed
Austrailia AICS
Listed
New Zealand
Listed
Japan ENCS (MITI)
Listed
Korea ECL
Listed

Properties.
Formula
C20H36N2
Formula mass
304.58
Melting point, °C
-36.1
Boiling point, °C
237
Vapor pressure, mmHg
237
Density
0.91 g/cm3 (20 C)
Solubility in water
<0.1 g/100 mL at 24 C

Hazards and Protection.
Storage
Keep in a cool, dry, dark location in a tightly sealed container or cylinder. Keep away from incompatible materials, ignition sources and untrained individuals. Secure and label area. Protect containers/cylinders from physical damage.
Handling
All chemicals should be considered hazardous. Avoid direct physical contact. Use appropriate, approved safety equipment. Untrained individuals should not handle this chemical or its container. Handling should occur in a chemical fume hood.
Protection
Wear appropriate protective gloves, clothing and goggles.
Respirators
Wear a NIOSH-approved half face respirator equipped with an organic vapor/acid gas cartridge (specific for organic vapors, HCl, acid gas and SO2) with a dust/mist filter.
Small spills/leaks
If you spill this chemical, FIRST REMOVE ALL SOURCES OF IGNITION. Then, use absorbent paper to pick up all liquid spill material. Your contaminated clothing and absorbent paper should be sealed in a vapor-tight plastic bag for eventual disposal. Solvent wash all contaminated surfaces with 60-70% ethanol followed by washing with a soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned.
Stability
No data.
Incompatibilities
May react with oxidizing agents Incompatible with isocyanates, halogenated organics, peroxides, phenols (acidic), epoxides, anhydrides, and acid halides.

Fire.
Fire fighting
Fires involving this compound can be controlled using a dry chemical, carbon dioxide or Halon extinguisher.
Fire potential
This chemical is probably combustible.
Hazards
When heated, vapors may form explosive mixtures with air: indoors, outdoors, and sewers explosion hazards.
Combustion products
Fire may produce irritating, corrosive and/or toxic gases.

Health.
Exposure effects
   Ingestion
See Inhalation.
   Inhalation
TOXIC; inhalation, ingestion, or skin contact with material may cause severe injury or death. Effects of contact or inhalation may be delayed.
   Skin
Contact with molten substance may cause severe burns to skin and eyes. See Inhalation.
   Eyes
See Inhalation.

First aid
 
   Ingestion
DO NOT INDUCE VOMITING. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. Be prepared to transport the victim to a hospital if advised by a physician.
   Inhalation
IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used.
   Skin
IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. If symptoms such as redness or irritation develop, IMMEDIATELY call a physician and be prepared to transport the victim to a hospital for treatment.
   Eyes
First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop.

Transport.
UN number
1673
Response guide
Hazard class
6.1
Packing Group
III
 
9. Aromatic amines