- Acintol C
- Unitol CX
- Liquid rosin
Amber to dark brown liquid with an acrid odor.
Manufacturing soap pastes, flotation agents, greases, paint, alkylated resins, linoleum, soaps, fungicides, asphalt emulsions, rubber formulations, cutting oils, sulfonated oils.
Registry Numbers and Inventories.
Swiss Giftliste 1
Japan ENCS (MITI)
Boiling point, °C
0.951 g/cm3 (20 C)
Hazards and Protection.
Keep tightly closed in a cool place in a tightly closed container.
Containers of this material may be hazardous when emptied. Since emptied containers retain product residues (vapor, liquid, and/or solid), all hazard precautions given in the data sheet must be observed.
Wear safety glasses or goggles, resistant gloves, and other appropriate protective equipment essential for your operation. Wear resistant gloves. To prevent repeated or prolonged skin contact, wear impervious clothing.
If overexposure has been determined or documented, a NIOSH/MSHA jointly approved air supplied respirator is advised in absence of proper environmental control. OSHA regulations also permit other NIOSH/MSHA respirators under specified conditions.
Small Spill - Absorb liquid on vermiculite, floor absorbent, or other absorbent material and transfer to hood. Large Spill - Persons not wearing protective equipment should be excluded from area of spill until clean-up has been completed. Stop spill at source, dike area of spill to prevent spreading, pump liquid to salvage tank. Remaining liquid may be taken up on sand, clay, earth, floor absorbent, or other absorbent material and shoveled into containers.
Strong oxidizing agents, strong acids.
Acid vapors, aldehydes, carbon dioxide and carbon monoxide.
Extinguish fire using regular foam, water fog, carbon dioxide, dry chemical. Water or foam may cause frothing which can be violent and possibly endanger the life of the firefighter. Water may be used to keep fire-exposed containers cool until fire is out. Wear a self-contained breathing apparatus with a full facepiece operated in the positive pressure demand mode with appropriate turn-out gear and chemical resistant personal protective equipment.
Swallowing small amounts of this material during normal handling is not likely to cause harmful effects. Swallowing large amounts may be harmful. This material can get into the lungs during swallowing or vomiting. This results in lung inflammation and other lung injury.
Nausea, vomiting, diarrhea, irritation
Can cause skin irritation. Symptoms may include redness and burning of skin, and other skin damage. Additional symptoms of skin contact may include: allergic skin reaction (delayed skin rash which may be followed by blistering, scaling and other skin effects).
May cause mild eye irritation. Symptoms include stinging, tearing, and redness.
Seek medical attention. If individual is drowsy or unconscious, do not give anything by mouth; place individual on the left side with the head down. Contact a physician, medical facility, or poison control center for advice about whether to induce vomiting. If possible, do not leave individual unattended.
Move patient to fresh air. Monitor for respiratory distress. If cough or difficulty breathing develops, evaluate for respiratory tract irritation, bronchitis, or pneumonitis. Administer oxygen and assist ventilation as required. Treat bronchospasm with beta2 agonist and corticosteroid aerosols.
Remove contaminated clothing and wash exposed area thoroughly with soap and water. A physician should examine the area if irritation or pain persists. Pesticides - remove contaminated clothing and jewelry. Wash the skin, including hair and nails, vigorously; do repeated soap washings. Discard contaminated clothing. Irritation - treat dermal irritation or burns with standard topical therapy
Irrigate exposed eyes with copious amounts of tepid water for at least 15 minutes. If irritation, pain, swelling, lacrimation, or photophobia persist, the patient should be seen in a health care facility.
USCG CHRIS Code
IMO Chemical Code
IMO Pollution Category
IMO Hazard code